QUESTION

My playstation 3 has a solid yellow light, how do I fix it?


curated by 226 crowd contributors

We pulled together 11 of the most popular web sites to create this page, including theps3ylod.hubpages.com, www.ifixit.com, www.jameco.com. We've organized their information into the most commonly discussed topics below, ranging from Yellow light of death to Power supply ps3. A total of 56 crowdworkers were involved during the process, of which 31 of them gathered the information, 25 of them organized the information by different topics, and 0 of them synthesized the information into this article.


Overview

Yellow light of death: Yellow light of death on playstation 3

Repair directions: This is a set of instructions for fixing a Playstation 3 with a solid yellow light. This kind of repair is called re-flowing. However, it is not a permanent fix, and could cause other problems with the console.

Reasons for ylod: There's no absolute cause of the YLOD, but there are a couple theories. One main theory is the rapid heating and cooling of the motherboard. Here's a quick fix to the problem.

Options to repair ps3: You shouldn't attempt to fix a Sony PS3 yourself, it could void the manufacturer's warranty. Taking it to a repair shop will also void the warranty. Your best option is to have Sony repair the unit.

Thermal paste: This is a few step solution to the problem. This solution should fix your YLoD error. Easy to follow steps.

Vents, cooling and ventilation: Keep it well ventilated and keep the vents vacuumed out religiously.

Power supply ps3: Sounds like it could be a power supply issue. First try replacing the PSU.


Yellow light of death

Yellow Light of Death

Yellow light of death on playstation 3 .

(NOTE: If you follow ANY YLOD troubleshooting guide, be warned you risk making your PS3 worse. No YLOD "fix" is ever guaranteed to work.)

Your experience of the YLOD normally comes during intense gameplay when the whole console just freezes up, the game crashes, and you can do nothing to remedy the problem. Along with the console freeze, your Playstation 3 gives an audible alert that something is terribly wrong by giving a few short beeps.

The BBC's Watchdog website recently investigated the PlayStation 3's "Yellow Light of Death" (article), a problem many console owners have experienced for years. In the past, Sony has expressed its dislike for the term, saying that the flashing yellow light doesn't focus on one particular error, but any one of "a range of issues that may inevitably affect any complex item of consumer electronics."

When you start your console it powers up normally but after around two to three seconds your console will flash a yellow light and beep three times fairly rapidly, after that your console should start to continue to flash a red light that is the YLOD. In the manual however you may notice it states the above but the solution is to restart your console without any problems this is not the case because many ps3 owners can’t restart their ps3 after the YLOD.

The higher the temperature, and duration of overheating, the more permanent the possible damage. The unit is made up of the mainboard, GPU, CPU, and other hardware components. These components are all adhered to their respective hardware boards with solder, and, because solder is nothing more than a drop of a solid metallic stuff, if you let it get too hot or cool too quickly, the solder starts to break down and get brittle and the components disjoin: thus, the YLOD.
Was this just coincidence that this solder "reflow" fix cured the overall YLoD problem despite Sony's claim? After reading Watchdog's article, Sony fired back with a response, saying that the YLoD doesn't stem from a manufacturing problem, and actually "dogged" the site for suggesting that the basic solder reflow process "can properly be done cheaply and quickly." Sony said it was unfair to criticize the company for service charges outside the warranty. To get a better understanding of the drama, check out the article along with Sony's full response.

If the Yellow/Red Light still displays even after turning on the PS3 with the HDD out, then you can be sure that it isn’t the hard drive.

By removing the PS3 hard drive and turning on the PS3, you can very well find out if your hard drive is faulty and causing the YLOD

Repair directions

REPAIR DIRECTIONS

This is a set of instructions for fixing a Playstation 3 with a solid yellow light.

The following is a set of do-it-yourself instructions for getting a PS3 with a yellow light working again. This repair methodlogy is called re-flowing.
Reflowing is not a permanent fix and it has a chance of causing several other unpredictable problems, including the possibility of the yellow light returning
.
Tools Required:
  • Playstation 3 with yellow Light issue
  • Spudger
  • -#1 bit Phillips Head Screwdriver
  • Small Phillips Head Screwdriver
  • T8 Torx Screwdriver
  • T10 Torx Screwdriver

  • Begin by accessing the smart plate by using the tip of the spudger to remove the black rubber screw cover from the side of the PS3. Then remove the single 8.5mm T10 security torx screw from the smart plate.

    Pull the smart plate toward the hard drive bay, then lift it off the body of the PS3. Be sure to keep track of the small metal bracket loosely held in the top cover.

    Remove the following seven screws, (6) 52mm Phillips screws and (1) 30 mm Phillips screw. Lift the top cover from its rear edge and rotate it toward the front of the PS3.

    Remove the 7.7mm Phillips screw securing the ground strap to the chassis. Pull the AC-In cables slightly away from the rear cover for clearance to access the AC-In connector. While depressing its locking mechanism, pull the AC-In connector out of its socket on the power supply.

    On the bottom of the console, locate and snap off the plastic cover that holds the hard drive. Underneath the cover is a blue screw. Remove the blue screw with the smaller Phillips screwdriver.
    Pull on the metal tab connected to the hard drive until the hard drive comes out.

    Reasons for ylod

    REASONS FOR YLOD

    There's no absolute cause of the YLOD, but there are a couple theories.

    Fix a PS3 by Reflowing the Motherboard
    The YLOD is a hardware failure, as for the specific cause nobody is exactly sure how it happens but a repair shop which repairs consoles stated that the cause of the YLOD is a hardware malfunction on the motherboard due to rapid heating and cooling which then cause the board to break.

    Disconnect the Blu-ray power cable from the motherboard. Pull the connector straight up and out of its socket.

    Pull the control board ribbon cable straight up and out of its socket on the motherboard. Then remove the two 12mm Phillips screws securing the control board to the lower case and remove the board.

    An independent console repairer disassembled the devices and heated the motherboard in a special oven, re-heating the solder to a point where the metal could repair bad connections between the components and the circuit board. After this trick, all sixteen consoles began working again; five were later reported to malfunction again.

    Options to repair ps3

    Options to repair PS3

    You shouldn't attempt to fix a Sony PS3 yourself, it could void the manufacturer's warranty.

    I have a launch model 60 gig PS3, that I have now owned for 3 years, it has worked wonderfully, never had any issues, until this YLOD thing came. I took it to a local shop to see if they could fix it, and the guy there said something about possibly a firmware corruption, that the 2.50 update has something to do with all of the yellow lights.

    I have spent a fortune on phonecalls to them with this exact same problem. They stated I need to pay the £145 charge, that is after arguing my case over and over again. They even know that they have giver some people free replacements even out of warranty.

    I highly recommend biting the bullet and sending it to Sony. Fixing it yourself will bring about other issues, and if you don't do it right, you'll no longer have the option of sending it to Sony later because it will have been opened. What they'll charge is still significantly lower than the price of a full-on new system.

    I just went ahead and ponied up the $150 to Sony, because I needs my backwards compatability, and ended up getting a refurbished one back. Of course I lost all of my saves which sucked a lot.

    If you wanted to send it to Sony, they wouldn't even touch consoles with user-attempted fixes. So you *can* try it yourself, but again you risk further damage.

    Thermal paste

    Thermal Paste

    This is a few step solution to the problem.

    Here are some potential solutions:

    • Replacement of the thermal paste is the most common solution; not just the paste that contacts the heat sink, but also the paste underneath the RSX and CBE heat spreaders. Don't try this yourself if you are unsure, as there's a high risk of damaging the board if done incorrectly.

    • Replace the PSU3 and HDD.
    The thermal paste on the CPUand GPU has probably gone bad and needs to be replaced. Once these things are fixed properly, the high fan speed should go away.
    Of course these simple, common fixes only apply if the solder balls aren't damaged. If this happens, an exepnsive re-ball is the only solution. A new PS3 is likely less cheaper. Re-conditioned parts are readily available at good prices and a quality thermal paste will set you back £20 at most.

    Vents, cooling and ventilation

    Vents, cooling and ventilation

    Keep it well ventilated and keep the vents vacuumed out religiously..

    Keep it well ventilated and keep the vents vacuumed out religiously . Most likely, its thermal paste is going bad, but it could be other things. Your two options are to call Sony and get it sent to them or you can do 3rd party like "gophermods.com" who will fix it for 70 dollars.
    The vents may accumulate dust, but dust is sucked into the unit so the vacuum only helps for the immediate vent area, not what is being forced inside the unit and fan.
    You should raise it up to make sure the air can flow around it too keep it cool. Make sure the vents and fan of your PS3 are not blocked by dust or any other obstacles. You should check these once a month to make sure no dust has accumulated.

    Power supply ps3

    Power Supply PS3

    Sounds like it could be a power supply issue.

    Sounds like it could be a power supply issue. First try replacing the PSU. If that doesn't fix it, then it's an internal hardware problem that would need to be checked out.